Electronic sensor products must be in order to play its function , but also to stabilize the product 's use in rated environment, so in response to the installation before installing the control of environmental conditions , in order to comply with the choice of electronic sensor products for environment. Electronic sensor installation environment conditions and product requirements applicable conditions differ from other types of products , special attention should be otherwise in use may lead to product failure rate is too high or destroyed.
The first pre-installation considerations :
Note 1 with ambient light :.
1 ) Under normal circumstances, the electronic sensor products in the environment should be avoided as much as possible the use of , or the use of halogen spotlights and other light fixtures , lest interference sources in the environment.
2 ) Avoid direct sunlight or bright light , reflecting the sensor.
3 ) should prevent strong across the sensor window mirrors or reflective surfaces , such as stainless steel decorative surface light .
4 ) Install countertops leader, hard to avoid exposure to the table after the lights , after the basin converging reflection to the sensor, or easily cause malfunction.
5 ) Install dryers should be avoided following a highly reflective material existence .
6 ) is usually not more than 600FLUX easy to install illumination or by product description .
2 product installation spacing :.
1 ) in the same environment , such as the installation of multiple electronic sensor products, the adjacent two products should be sufficient clearance to avoid interference with each other.
2 ) wash utensils : 50CM above , shower appliances : 80CM above , urinal : 50CM above , Squat : 80CM above , for products marked as wide-angle sensor should be noted that a reasonable interval of each other .
3 Water pressure :.
Please supply pipeline design each bathroom independent control valve is installed , the water pressure should be within the scope of the product, according to product description regulate water pressure to meet the pressure requirements of the product .
4 Power
1 ) voltage AC power shall comply with the description of the scope of products , such as products not specifically described , it should ensure that the power supply voltage within the product 's rated voltage ± 10% range. ( This is the normal standard , and some products have wide voltage practicality ) . When using AC power , each sensing device must be installed in the bathroom separate power switch.
2 ) Install seat : Should rational planning , such as dryers , soap dispenser height control box installation location , installation height and position of embedded box , as well as water pipe layout, wiring , etc. , should be planned well in advance .
3 ) installation of electronic appliances should be preceded by induction water supply pipes drain cleaning , removal of impurities inside the tubes .
4 ) Select the appropriate sensor according to specific ware.
5 ) In addition, our company's products at the factory have been sensing distance adjustment , with a factory setting , under normal circumstances , the installation does not require re- adjustment to normal use, the installation environment when Ruoyin special needs adjustment, according to product model reference guide product specification induction distance adjustment . If you pay attention to these during installation, the machine will likely not work properly , the specific installation instructions please refer to each product's installation guide manual.
Maintenance Section .
1 Protect the cable jack and the solenoid valve to prevent water splashing into the solenoid valve coil caused a short circuit, causing damage to the product , do not use acid, alkali or hard objects ( abrasive cleaning agents ) , such as cleaning or making knock sensor window damage does not work.