Section Installation Notes :
1 . Recommended to refurbishment good around the walls , carefully move the cylinder to prevent bruising product , after adjustment screws in place to block level , from the ground to the bottom of the skirt 1CM, drain inserted into the drain hole .
Section repairs and maintenance :
1 . Use a soft, dry cloth to clean the bathtub.
2 . If slight dirt , please stick with a soft cloth or sponge neutral detergent ( no friction ) cleaning , nylon products cause the product to lose gloss, easy to stain so do not use .
3 . In remove stubborn dirt , use a clear alcohol .
4 . When using a dedicated bathroom cleaners, be sure of their considerations on the container as described in the proper use of the wrong use of the body will have a negative impact , and easy to make products appear some adverse conditions .
5. When using fungicides , please follow the instructions to use fungicides . After use, wash with clean water and clean with a dry cloth to dry.
6. During cleaning , because the following items would adversely affect the human body , and some products can cause adverse conditions , so what use is strictly prohibited products : Acid \ alkaline solvents , drugs ( such as hydrochloric acid ) , and acetone, thinners and other solvents, to dirty powder, polishes , nylon broom , emery cloth , etc.
7 . Must be properly installed bath method is not properly installed and used for the bath caused by the failure , the company responsible.
8. Do not miss the first turn on the water when the hot water , as hot water repeatedly let go first will reduce the life of a bathtub , the water should be hot and cold water to the required temperature.
9. Non- ferrous items into the bathtub to avoid rust, if any rust use toothpaste with a soft cloth to scrub .
Section install steel cylinder common sense :
1 . Product installation must see instructions at the bottom of a bathtub mat brick prohibited , or when the use of topical point or line contact , body weight so that the local steel pressure is too large , it may cause a local deformation convex , can cause serious local glaze cracks or damage . The bottom of the tub after installation to determine whether there is a hard object support , hand percussion bathtub underside , from the sound judgment can be made , the bottom foam board do not remove , the bottom can not pad items, vacant place with a hard object and do not pad the underside steel tub contacts . Bath surrounding brickwork support , careful not to damage the cement sticky gloss glaze on glaze .
2 . Not easy to clean as new after installing anti-slip bathtub not removed the protective film , anti-slip layer of dust and other dirty things defile .
3 . Contents of the newly installed water pipes tend to have dirt or rust water , pollution bathtub. In such circumstances the use of " clean porcelain treasure" and other special cleaning agent . To fundamentally solve only clean water pipe used for some time , and there is no bathtub above phenomenon.
4 . Note :
Improper installation , handling, use may produce the following adverse defects