The first pre-installation considerations :
1 . After opening the box the first inventory of related accessories are available, the product is intact.
2 . Should be checked before installing the toilet and outfall channel for foreign objects in the product : install a toilet on the ground must be flat, sand, stone and other debris should be cleaned up .
3 . Not self- toilet outfall open big .
4 . Toilet installed for a period of time ( about one hour ) , continuous flushing several times to ensure the smooth flow of sewage pipes , clear construction debris left behind .
5. Before installing the siphon toilet to confirm compliance with the requirements under drains . ( 1 ) the inherent siphon toilet S- trap , has played a role in every foul . ( 2 ) between the toilet and the sewer trap trap some air to produce air flow toilet flushing can not be excluded , resulting in gas fan hinder toilet siphon effect causes the water inside the toilet is drained slowly The dirt can not be discharged .
6. Special Note: Do not use the toilet installation pure cement installation to avoid cracking due to expansion of cement products caused ; should be installed to ensure that the toilet is level , before and after anti- ban high- low , about injustice, this phenomenon will affect the toilet flushing water features.
Section Installation Notes :
1 . Before installing the wall away from the outfall confirmed reservation is consistent with the selected product , installed fixing bolts . ( Note: To level with the ground floor outfall to the ring seal ) .
2 . The toilet correctly placed ( toilet sewage outfall on positive ground or wall outfall ) , pen and toilet bolts accurately delineate the underside bottom position , the appropriate bolts driven into the ground .
3 . Installing the toilet lid , check water, drainage pieces are installed, installed angle valve ( check for leaks ) , installed the toilet ring.
4 . Align the screw holes slowly down the toilet , so the toilet bolts through the mounting holes at the bottom of the toilet ring and outfall to ensure positive , with a slight rocking motion or pressure of the toilet , the toilet until smooth . ( Suggestion: keep the gap between the rear wall and the wall of the toilet tank 19 ± 6mm). Finally , as the situation along the bottom edge of the toilet sealant around a closed line , a sealed glass or plastic coated (neutral glass, plastic ) .
5. Install water hose , tighten the mounting nuts , making toilet solid, put decorative cap bolts . ( Based on actual local conditions , adjust the water level in the tank to the appropriate accessories : installed keys: cover tank cover : try flushing : manual installation and adjustment by the toilet lid cover installation : Check for leaks at the inlet ) .
Section Maintenance :
In the process of using the product , you should note the following matters :
1 . Users at least once a week to clean the toilet .
2 . If the user location is hard water, the water , the water must be kept clean more holes .
3 . Often turning toilet cover gasket can cause tightening loose , tighten the cover nut.
4 . Do not strike , trample Wei Tao ware.
5. Do not close the toilet lid speed fierce.
6. Rub gently with water for soft ware Wei Tao , do not use abrasive or strong effect of ( pH ) of the cleaning agents, solvents and other cleaning toilet tank fittings , and accessories to avoid damage to the product surface , resulting in the loss of the Company shall otherwise is not responsible.
7 . Do not stand in the toilet detergent into the machine off, rinse with water after the close .
8. Do not use high temperature water hot wash Methodist pottery ware.